MDC3105LT1G

The MDC3105LT1G is an Inductive Load Driver intended to replace an array of three to six discrete components with an integrated SMT part. It can be used to switch 3 to 6VDC inductive loads such as relays, solenoids, incandescent lamps and small DC motors without the need of a free-wheeling diode.

• Provides a robust driver interface between DC relay coil and sensitive logic circuits
• Optimized to switch relays from a 3 to 5V rail
• Capable of driving relay coils rated up to 2.5W at 5V
• Low input drive current and good back-to-front transient isolation
• Internal Zener eliminates need for free-wheeling diode
• Internal Zener clamp routes induced current to ground for quieter system operation
• Guaranteed OFF-state with no input connection
• Supports large systems with minimal OFF-state leakage
• ESD resistant in accordance with the class 1C human body model
• Low sat voltage reduces system current drain by allowing use of higher resistance relay coils

Applikationer

Power Management, Communications & Networking, Signal Processing

Noter

Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.