SST25PF020B-80-4C-SAE

The SST25PF020B-80-4C-SAE is a 2MB Serial Flash Memory features a four-wire, SPI-compatible interface that allows for a low pin-count. This device is enhanced with improved operating frequency and even lower power consumption. SST25PF020B SPI serial flash memory is manufactured with proprietary, high-performance CMOS SuperFlash technology. The split-gate cell design and thick-oxide tunneling injector attain better reliability and manufacturability compared with alternate approaches. The device significantly improves performance and reliability, while lowering power consumption. The devices write with a single power supply of 2.3 to 3.6V for SST25PF020B. The total energy consumed is a function of the applied voltage, current and time of application. Since for any given voltage range, the SuperFlash technology uses less current to program and has a shorter erase time, the total energy consumed during any erase or program operation is less than alternative flash memory technologies.

• Serial interface architecture - SPI compatible - mode 0/3
• High speed clock frequency - 80MHz
• Superior reliability
• Endurance - 100000 cycles typical
• Greater than 100 years data retention
• Low power consumption
• Flexible erase capability
• Fast erase and byte-program
• Auto address increment (AAI) programming
• Decrease total chip programming time over byte-program operations
• End-of-write detection
• Software polling the BUSY bit in status register
• Busy status readout on SO pin in AAI mode
• Hold pin - Suspends a serial sequence to the memory without deselecting the device
• Write protection - Enables/disables the lock-down function of the status register
• Software write protection - write protection through block-protection bits in status register

Applikationer

Computers & Computer Peripherals, Industrial, Communications & Networking, Consumer Electronics, Commercial, Medical